At last…

Last week was a rough one that blindsided me, and home feels a lot emptier for it, but I’ve been dealing by lavishing attention onto the other four-footed residents and by keeping busy.  And keeping busy at this time of year means boat work, in this case in the form of the salon ceiling/bridge deck, which is at long last securely in place.

When last I left off, we’d been prepping out the areas where the edges would join. This included the forward edge of the remaining deck, the salon bulkheads and underside of the bridge.

Think of it like a layer cake – one where the upper and lower layers are fixed in place, and the inner layer (the new laminate core) would be *very* carefully slide in between. Only this layer measures approximately 8’ x 8’, weighs I can only imagine how much, has a camber to match the original curves and exact dimensions of the opening with only millimeters to spare and would be eased in by two people, (one of which is only 5’2”.) Add into this equation that every edge, inner and outer, upper  and lower, needed to be prepped in epoxy, and upon alignment, lagged into place before that epoxy set.  In other words, there was zero margin for error.

Below: The space we need to slip the core through. (Small scrap piece of correct thickness in place to test clearance.)

Below:  The Gazebo with the core on top — this made things much easier.

The key to pulling this off was tons of preparation and planning, repeated ‘dry-fit’ test runs, and everything coming together just right. We had everything in place. Resins, mixing pots and spreaders, fiberglass, brushes, hardware, tools, clamps, stands to support the wood, braces for alignment, etc. With the frame we’d used to originally laminate the wood set up on legs and looking like a gazebo in the cockpit, it supported the core at the right height and allowed us to slide it smoothly into the cabin.

Below: the view from the cockpit. This extends slightly further than the original bridge, which will provide more space above and more protection to the cockpit door below.

Once inside, we angled it down, braced it, wet out all areas that would meet with West System epoxy. We eased strips of pre-cut chop strand mat up from beneath where they would extend down, and smoothed the upper halves of these strips onto the top edges of the core.

Next,  we quickly spread West, thickened to a peanut butter consistency with 406 filler, along the salon bulkheads and bridge underside. At this point I wasn’t taking pictures, as we were racing to cover large areas and get everything in place before the epoxy began to cure. That, and were I to pick up my camera it would likely still be covered in resin. Once everything was wetted out the core was raised into final position and screws went in to set it into position, joining it to the leading edge with clamps, the bridge, and temporary 2’x4’s shimmed and angled to match the final alignment.

And there you have it. Next round, screws out and we’ll be laminating ribs in. After that, we’ll re-glass the underside, then go above, fill all the screw holes with epoxy, and glass the bridge deck.

Advertisements

One response to “At last…

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s